您好,欢迎来到济南道源丰达机械制造有限公司网站!

服务热线:400-9901-557/18678880998

微信号:18678880998

淘宝店铺:点击进入

1688店铺:点击进入

爱采购商城:点击进入

拼多多商城:点击进入

技术资料 当前位置:首页-技术资料保证旋转供料器运行的措施

保证旋转供料器运行的措施

发布时间:2022-05-14 来源:http://www.sddyfd.com/

旋转供料器俗称关风机、卸料器、旋转给料阀、旋转卸料阀、旋转阀等,是散状物料的主要输送设备,以可靠性强、实惠等优点广泛应用在粮食加工、化工原料、塑料冶金、能源矿业、建材水泥等行业。该产品在使用过程中,为了保证运行的稳定性,有一些事项是需要注意的,下面就给大家分享一下该设备的操作要求吧。
Rotary feeder, commonly known as shut-off fan, unloader, rotary feeding valve, rotary unloading valve, rotary valve, etc., is the main conveying equipment of bulk materials. With the advantages of strong reliability and affordable price, it is widely used in grain processing, chemical raw materials, plastic metallurgy, energy mining, building materials, cement and other industries. During the use of this product, in order to ensure the stability of operation, there are some matters that need to be paid attention to. Let's share the operation requirements of this equipment.
1、供料器应按规定的方法安装在固定的基础上,移动式供料器正式运行前应先将轮子用三角木楔住或用制动器刹住,以免工作中产生移动;
1. The feeder shall be installed on a fixed foundation according to the specified method. Before the formal operation of the mobile feeder, the wheels shall be wedged with triangular wood or braked with brakes to avoid movement during operation;
2、皮带打滑时不可用手去拉动皮带,以免发生事故;
2. Do not pull the belt by hand when the belt slips to avoid accidents;
3、运行出现胶带跑偏现象时,应停机调整,不得强行使用,以免磨损边缘和增加负荷;
3. In case of belt deviation during operation, stop the machine for adjustment and do not use it forcibly to avoid wearing the edge and increasing the load;
4、皮带供料器应空载启动,等运转正常后方可入料,千万不能先入料后启动;
4. The belt feeder shall be started without load and can be fed only after normal operation. It must not be started after feeding first;
5、不得输送酸碱性的油类和溶剂成份的物料;
5. Do not transport acid-base oils and materials with solvent components;
6、旋转供料器使用前须检查各运转部分、胶带搭扣和承载装置是否正常,防护设备是否全;
6. Before using the rotary feeder, check whether the operating parts, belt buckles and bearing devices are normal and whether the protective equipment is complete;
7、胶带的涨紧度须在启动前调整到合适的程度;
7. The tension of the tape must be adjusted to an appropriate degree before starting;
8、有数台供料器串联运行时,应从卸料端开始,按顺序起动,正常运转后,方可入料;
8. When several feeders operate in series, they should start from the discharge end and start in sequence. After normal operation, they can be fed;
9、工作环境及被送物料温度不得高于50摄氏度和低于零下十摄氏度;
9. The working environment and the temperature of the delivered materials shall not be higher than 50 ° C and lower than minus 10 ° C;
10、输送带上禁止行人或乘人;
10. No pedestrians or passengers are allowed on the conveyor belt;
11、有多台供料器平行作业时,机与机、机与墙之间应有一米的通道;
11. When multiple feeders operate in parallel, there should be a one meter channel between machines and between machines and walls;
12、停机前须先停止入料,等皮带上存料卸尽方可关停设备;
12. Before stopping the machine, the feeding must be stopped first, and the equipment can be shut down only after the materials stored on the belt are discharged;
13、旋转供料器的电动机须绝缘良好,移动式供料器电缆不要乱拉和拖动,电动机要可靠接地。
13. The motor of rotary feeder shall be well insulated, the cable of mobile feeder shall not be pulled and dragged randomly, and the motor shall be reliably grounded.
以上就是为大家介绍的有关广东旋转供料器的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.sddyfd.com/
The above is about Guangdong rotary feeder. I hope it will help you If you have any questions, please contact us We will provide you with professional service http://www.sddyfd.com/